Camera - 360 Vision Predator-Dualview Installation And Configuration Manual

Predator-Dualview Installation Manual V2.1.21.1
PTZ position co-ordinates are also shown, use the refresh button to refresh the data if the camera has been
moved.
PTZ position co-ordinates can also be added manually, use the go button to send the camera to the coordinates
set.
Use the pan preset offset to set the camera to 0°, this would be used to set the camera to North if using the pan
compass option.
Use the clear button to reset the pan or tilt offset settings.

7.2.4 Camera

• Camera - Cannot be edited, shows label/name given to the camera.
(See Video - Camera - page 17).
The Camera page, offers options to:-
Camera Settings
• Digital Zoom - Enable digital zoom. Default is off.
• White Balance - Select White Balance settings to suit camera location.
(See page 58 for table of options).
• Wide Dynamic range - Enable WDR. Options available are ON, Auto and Off. Default is off.
• Zoom speed - Select zoom speed of the lens. Options are slow, medium, high and highest. Default is
high.
• Proportional Zoom - Automatically reduces/increases pan/tilt speed depending on zoom ratio. Default
is on.
• Freeze Preset - This option freezes the image, when moving between presets. This can help reduce
the bandwidth. Default is off.
• Day Aperture - Can be used to increase the picture detail. Default is 10.
• Sensor Frame Rate - Can be used to set the camera to suit 25fps or 30fps. Unit must be rebooted for
settings to apply. Default is PAL.
(See Video - page 17).
OK to program the new settings into the Predator.
Cancel to abandon the changes to the advanced feature settings.
© 360 Vision Technology Ltd.
Page 21