Preparing A Vacuum-Compatible N-470 For Connecting To The Electronics - PI N470 Series User Manual

5 Installation
5.3 Preparing a Vacuum­Compatible N­470 for Connecting to the
Electronics
Figure 10:
Assigning the stranded wires and the cable shield
Letter
a
b
c
Requirements
 You have read and understood the general notes on installation (p. 17).
 The cable on the air side of the N-470 is not connected to the electronics.
Tools and accessories
Suitable vacuum feedthrough

Air side and vacuum side connector (male or female) for vacuum feedthrough

K030B1063 air side cable (p. 13)

Suitable tools for wiring the connectors

22 Version: 1.2.0
Vacuum-compatible N-470: Connections for the vacuum feedthrough
1 Vacuum-side connector for the N-470's cables
2 Vacuum feedthrough
3 Connector for the K030B1063 air side cable (p. 13)
4 LEMO connector, 3-pin, see "Pin Assignment" (p. 46)
Wire color
Vacuum­side Air­side
actuator cable connecting cable
Red White
Black Brown
--- ---
Function
Piezo voltage 0 to 80 V
Piezo voltage ground
Bare cable shield
MP125E
Signal
PIEZO+
PIEZO-
---
N­470 Linear Actuator