Download Print this page
PI M-22 Series Short Instructions

PI M-22 Series Short Instructions

Linear actuators

Advertisement

Quick Links

MP122EK 5.0.0 10/2020. 1.2
Linear Actuators
Short Instructions
M-22x / M-23x / N-381
User Information
These short instructions contain an overview of the most important safety and handling instruc-
tions for installing linear actuators (hereinafter referred to as „positioner") with the product
numbers specified above (x: any number).
Subject to change. These short instructions are superseded by any new release. The latest respec-
tive release is available for download on our website.
Downloading and Reading the Manual
The actions during installation, startup, operation, and maintenance require additional information
from the manuals of the positioner and/or the electronics.
Manuals may be titled as follows: „User Manual", „Technical Note".
Downloading the manuals from the website
1. Open the website www.pi.ws.
2. Search the website for the product number (e.g., C-663.12) or the product family (e.g., PICMA®
Bender).
3. Click the corresponding product to open the product detail page.
4. Click Downloads.
The manuals are displayed under Documentation.
5. Click the desired manual and fill out the inquiry form.
The download link will then be sent to the email address entered.
If you cannot find the manual you are looking for or if you have any questions: Contact our custo-
mer service department via service@pi.de.
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstr. 1, 76228 Karlsruhe, Germany
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws
M O T I O N | P O S I T I O N I N G

Advertisement

loading
Need help?

Need help?

Do you have a question about the M-22 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PI M-22 Series

  • Page 1 If you cannot find the manual you are looking for or if you have any questions: Contact our custo- mer service department via service@pi.de. Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstr. 1, 76228 Karlsruhe, Germany Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws...
  • Page 2 MP122EK 5.0.0 10/2020. 1.2 A cable break leads to failure of the positioner. General Safety Install the positioner so that the cable is Information cannot be bent too strongly or crushed during operation. Intended Use Starting and Operating The positioner is a laboratory device as defined Excessively high or wrongly connected opera- by DIN EN 61010-1.
  • Page 3 MP122EK 5.0.0 10/2020. 1.2 Operation Mounting with Clamping Shank 1. Prepare a suitable mounting with clamping Operating the positioner in environments that fixture (2) (refer to the manual for dimen- increase electrical conductivity could damage sions). the positioner. 2. Insert the positioner (3) into the clamping Keep the positioner free of liquids and fixture.
  • Page 4 Maintain the positioner only ac- to the market after 13 August 2005. cording to the instructions in the If you have an old device from PI, you can send manual. it to PI free of charge. The positioner is maintenance-free.