DSC LE4000 Installation Manual page 23

Digit 1
The communicator status codes indicate the signal levels with digit 1 and 2, a network status
with digit 3, and the trouble status with digit 4 and 5 as indicated in table above. For example
status code 11000F displays following status:
1 – On = Signal indicator 1, is ON
1 – On = Signal indicator 2, is ON
0 – OFF = Network indicator, network is working
00 – TROUBLE INDICATOR = there is no trouble on the communicator.
F – Future code not assigned yet. It is sixth hexadecimal digit. It could be also ' - ' (dash)
instead of letter F (11000-).
In this example both signal indicators are on indicating that communicator has excellent signal
level; the network indicator is OFF showing that we do not have any network problems and
trouble indicators are both OFF indicating that we don't have any trouble on the
communicator.
[985] Radio Initialization Status
The radio initialization status is intended to provide the installer with real time status of radio
communication. The radio initialization status is displayed in 8-bit toggle option. Each digit
indicates one task in radio initialization process that is complete step in entire process of radio
initialization as following:
1. Radio power up
2. Received the SMS from C24
3. Radio reset
4. Radio attached to network
5. Not used
6. Not used
7. Receiver 3 Initialized
8. Receiver 4 Initialize
The following table shows each digits position in status code and each digit value and its
assigned meaning in the 8-digit code:
Table 13: Radio Initialization Status - 1-8 bits completion
Bit
Not Completed
Completed
For example, the radio initialization status code 12-45--- indicates that Radio has been powered up, it has
received SMS signal from C24, the radio is attached to the network, and Receiver 1 has been initialized.
This code could be followed with...567 if Receivers 2, 3, and 4 are initialized where applicable.
If the radio initialization status code does not indicate any problems, proceed with installation as per this
manual. If troubles are reported, reset the initialization process. If this action does not fix the problem,
refer to Troubleshooting section in this manual.
Digit 2 Digit 3
1 2 3
- - -
1 2 3
Digit 4 & 5
06
Receiver Not Avail-
07
Receiver Supervision
08
09
C24 Configuration
0A
0B
Module configuration
0C
4 5
- -
4 5
23
Digit 6
Future use
able
trouble
FTC Trouble
SMS Failure
Future use
Trouble
6 7
- -
6 7
F
F
F
F
F
F
F
8
-
8