Introduction - Mira Extreme Thermostatic Installation & User Manual

Power shower
Hide thumbs Also See for Extreme Thermostatic:
Table of Contents

Advertisement

Section
1
Thank you for purchasing a quality Mira product. To enjoy the full potential of your new
shower, please take time to read this guide thoroughly, and keep it handy for future
reference.
The Mira Extreme Thermostatic is a surface mounted all-in-one thermostatic power
shower. It is designed for use with a mains voltage electrical supply and gravity fed hot
and cold water supplies. It features a built-in pump unit, thermostatic mixer assembly
and separate power, flow buttons and temperature control.
The thermostatic mixer assembly responds to changes in incoming water temperature
to maintain the showering temperature selected. The temperature control is preset to
give a maximum showering temperature of 41°C. However, it can be adjusted to suit
installation or user requirements.
An override button is fitted to the temperature control . This allows the user to override
the maximum temperature and select higher showering temperatures. The button can
be disabled, if required.
The product is fitted with a 15 mm dual entry push-fit inlet manifold which allows pipe
connections to the top, bottom or rear of the power shower. The inlet manifold also
contains inlet filters and check valves.
The shower control is supplied with Mira Logic power shower fittings. These fittings
consist of an adjustable spray handset with four different spray actions (start,
champagne, massage and economy), flexible hose, adjustable clamp bracket assembly,
slide bar and supports, hose retaining ring and wall mounted soap dish. The fittings are
available in a white/chrome or all white finish.
The Mira Extreme is not suitable for use in institutional/commercial applications. It
must not be used with mains water pressure applications; for example, instantaneous
electric heaters, instantaneous gas water heaters, unvented mains pressure systems,
pumped shower systems and some combination-type storage systems.
If you experience any difficulty with the installation or operation of your new shower
control, please refer to "Fault Diagnosis" before contacting Kohler Mira Limited.
Our telephone and fax numbers can be found on the back cover of this guide.

Introduction

3

Advertisement

Table of Contents
loading

Table of Contents