Table of Contents
Advertisement
2.4.
Remove the small label covering
the retaining screw on the
temperature hub. Unscrew the
retaining screw and remove the
temperature hub.
Note! This will void the factory
setting.
Caution! When resistance is felt
DO NOT USE FORCE to turn the
spindle any further as this is the
maximum
temperature from the appliance
with the available hot water storage
temperature.
DAMAGE
components.
2.5.
Turn the temperature spindle until
the required
temperature is obtained.
Warmer
anticlockwise
Cooler ⇒ Turn spindle clockwise
2.6.
Press the Stop button to stop the
water flow.
2.7.
Refit the temperature hub with the
pip on the temperature hub aligned
to the slot on the thermostatic
cartridge. Secure with the retaining
screw.
2.8.
Refit the temperature knob.
Caution! If resistance is felt when
turning the temperature knob DO
NOT USE FORCE to turn the knob
any further as this will DAMAGE
internal components.
2.9.
Check that the temperature knob
can be fully turned in both
directions.
2.10. Check the maximum temperature
setting. If necessary repeat the
temperature adjustment until the
correct setting is achieved.
24
obtainable
FORCE
the
internal
maximum water
⇒
Turn
spindle
will
Temperature
Hub
Temperature
Hub Retaining
Screw
Temperature
Spindle
Align the pip on the
temperature hub with
the slot in the
thermostatic cartridge.
Advertisement
Table of Contents
