Registering Sub Addresses And Local System Data - Sony PCS-3000 Operating Instructions Manual

Registering Sub Addresses and Local System Data

Note
You always need to register the LOCAL NUMBER (LN) and COUNTRY
CODE (CC) when you use this system.
You have to register required information about your own system.
1
Select [LDN] from the SETUP menu.
The LDN menu appears.
LOCAL DIRECTORY NUMBER
LOCAL NUMBER (LN)
A 1
A 2
B 1
B 2
COUNTRY CODE (CC)
AREA CODE (AC)
2
Enter your telephone number and sub address in the LOCAL
NUMBER (LN) section.
Enter the telephone number connected to the ISDN A jack at the rear
of the Rollabout Processor in the lines headed A1 and A2.
If you installed the optional PCS-I300 BRI Board into the Rollabout
Processor, enter the telephone number connected to the ISDN B jack in
the lines headed B1 and B2 also.
Notes
• When using a dial-in service, enter hyphen (–) at the end of the line
numbers entered on A1 line.
• Always place a hyphen (–) between the local switch number and the
subscriber number.
• When setting a sub address, always follow the telephone number
with an asterisk.
3
Enter your country code on the line headed COUNTRY CODE (CC)
(e.g., enter "1" for the US.)
4
Enter your area code on the line headed AREA CODE (AC).
Be careful not to enter the first zero (e.g., enter only "408" for
California).
5
If you are using a private branch exchange (PBX), enter your outside
telephone number in line marked LOCAL CALL (e.g., enter "9" if you
have to dial nine to get an outside line).
LOCAL CALL
+LN
LONG DISTANCE CALL
+AC+LN
INTERNATIONAL CALL
+CC+AC+LN
1 2 3
delete clear
4 5 6
copy
7 8 9
SPID
0 – – x
EXIT
Chapter 2 Settings
(Continued)
2-13