About Backup - Sony PCS-3000 Operating Instructions Manual

Basic Adjustments

About Backup

1-16
Chapter 1 Using the Basic System
3
Select [TRACK].
TRACK check box changes to blue.
Try moving the subject to see if the frame tracks it automatically.
When the frame tracks the subject, proceed with the step 4.
When the frame does not track the subject, repeat the steps 2 and 3
until the frame starts tracking the subject while adjusting the lighting
and the position of the subject so that the color and brightness of the
subject is optimized.
4
Select [AT].
The AT (automatic target tracking) function starts and the frame
disappears from the screen.
To cancel the AT (automatic target tracking) function
Select [TRACK] again so that the color of the TRACK check box returns
to the original color.
To keep the size of the memorized subject as is
After performing the pan/tilt operation so that a subject is placed into the
frame, select [AUTO ZOOM].
To cancel the function, select [AUTO ZOOM] again so that the color of the
AUTO ZOOM check box changes to blue.
Then, repeat the step 3.
If the frame is repeatedly extended to the full screen
The camera does not recognize the subject. Select [TRACK] again and go
back to the step 2.
If the lamp at the side of the lens lights up
The camera is not capturing the memorized subject correctly.
In this case, perform the pan/tilt operation so that the subject comes into
the screen. Or have the subject memorized onto the camera again.
The memories of the preset and clock settings are erased when the POWER
switch on the camera unit is set to OFF. To retain those memories, set the
BACK UP switch at the rear of the camera unit to ON.
Notes
• In the camera unit, the built-in lithium battery acts as the power source for
retaining the memories and is kept charged as long as the system is used.
If the system is used for shorter period of time with the BACKUP switch
set to ON, however, the battery is gradually discharged. Besides if you do
not use the system at all for almost 12 weeks, the battery is completely
discharged. To retain the memories of the settings, you should recharge
the battery.
• To recharge the battery, connect the camera unit to the Rollabout
Processor and leave it for approximate 48 hours with the POWER switch
on the camera unit set to ON.