Sony PCS-3000 Operating Instructions Manual page 108

Message List
Error number definitions and remedies
Error
Definition
number
000 No specific fault
001 Unassigned number
002
003
006
016 Normal disconnection
017 User busy
018 No user responding
019 User alerting, no answer
020 No reply
021 Call rejected
022 Number changed
026
027 Destination out of order
028 Invalid number format
031
034
041
042
043
044
047
057 Bearer capability not authorized
058
070
088 Incompatible destination
091 to 111
131 Wrong board
132 Wrong SPID number
160 Wrong sound setting
161 Wrong baud rate
162 Wrong connection
163 Line registration incomplete
300 Mistake in live number registration
301 Required upgrade card is not installed
If you still get the same error number after attempting the appropriate remedy, or when you cannot make a
connection, contact your nearest Sony dealer.
A-8
Appendix
Try dialing again.
Check that the number is correct.
Wait for a while and then try dialing again.
Wait for a while and then try dialing again.
Wait for a while and then try dialing again.
(Normal disconnect)
Wait a while and then try dialing again.
Check that the remote party's system is connected and check their telephone number.
Check that the remote party's system is connected and check their telephone number.
Check that the remote party's system is connected and check their telephone number.
Check that the remote party's system is connected and check their telephone number.
Check to see if your partner's telephone number is the correct one.
Wait a while and then redial
Check to see if the remote system is functioning normally.
Check to see if your partner's telephone number is the correct one.
Wait a while and then redial.
Wait a while and then redial.
Wait a while and then redial.
Wait a while and then redial.
Wait a while and then redial.
Wait a while and then redial.
Wait a while and then redial.
Check to see that the 56K/64K line rate (56 Kbps or 64 Kbps) is set correctly.
Check to see that the 56K/64K line rate (56 Kbps or 64 Kbps) is set correctly.
Set to 56K and try dialing again.
Check to see if the remote party system is connected.
Switch the power off and then back on again. Try dialing again.
Check the line interface board and the [LINE I/F] setting in the DIAL LIST menu.
Set the SPID number correctly.
Set the [AUDIO BAND] setting in the SETUP menu to the same rate as the
parties you are connected with.
Set the [BAUD RATE] in the SETUP menu to the same rate as the parties you
are connected with.
Check to see that all remote parties are using a PCS-5000/4000/3000 series
system.
Register all the items in [LOCAL DIRECTORY NUMBER] in the SETUP menu if
you are connected to multiple remote parties.
Register all the items in [LOCAL DIRECTORY NUMBER] in the SETUP menu.
To have a multi meeting, remote PCS-4000 will need to install the PCS-UC400
upgrade card.
Remedy