Adjusting The Vertical Gap; Adjusting The Horizontal Gap - Hunter TCX575 Operation Instructions Manual

Adjusting the Vertical Gap

Adjusting the Horizontal Gap

34  4. Maintenance, Calibration and Replacement Parts
3. Fully tighten the adjustment screws starting with the head retaining bolt.
Release the post and reposition the tool head on the rim for gap
adjustment.
1. Reposition the tool head on the rim and lock it in place with the head
position lock. Using a feeler gauge, check the distance between the tool
head and the rim. The distance should be .06 inch.
.06 inch
GAP
2. If the gap is not correct, release the head position lock and adjust the nut
beneath the post locking system cover to adjust the gap. The cover must
be removed. Back off the nut to increase the gap and tighten to reduce
the gap.
3. Reposition the tool head on the rim and lock it in place with the head
position lock. Re-check gap.
1. Release the tool head, then reposition it on the rim and lock it in place
with the head position lock.
POST
LOCKING
SYSTEM
COVER
ADJUSTMENT
NUT
Operation Instructions for TCX575 Tire Changer