Hunter TCX575 Operation Instructions Manual page 43

Operation Instructions for TCX575 Tire Changer
2. Using a feeler gauge, check the horizontal gap between the tool head
and the rim. The distance should be 1/16 inch.
3. If the gap is not correct, release the head position lock and adjust the
nuts beneath the horizontal post locking system cover to adjust the gap.
The cover must be removed. Back off the nuts to increase the gap and
tighten to reduce the gap.
ADJUSTMENT
NUTS
To ensure that the horizontal locking plate functions
CAUTION:
correctly, the two nuts must be adjusted symmetrically.
4. Reposition the tool head on the rim and lock it in place with the head
position lock. Re-check gap.
5. When the adjustments are complete, check the gap between the hook of
the tool head and the outboard safety hump of the rim. The distance
should be between .08 and .16 inch. If not, repeat the calibration
process.
1/16 inch
GAP
HORIZONTAL
POST LOCKING
SYSTEM COVER
REMOVED
.08 - .16
inch GAP
4. Maintenance, Calibration and Replacement Parts  35