Front Axle; Remove - Taylor-Dunn RE-380-36 Service And Replacement Parts Manual

Front Axle

REMOVE

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
1: Raise the front of the vehicle and support with jack stands.
2: Remove both front wheels. Refer to Tires and Wheels section for information regarding removing the front
wheels.
3: Tie up or support the front axle so it can not fall out of the vehicle.
4: Disconnect the drag link ball joint or rod end from the steering knuckle or the steering gear pitman arm.
Note: Refer to the Replacing the Ball Joints section for information regarding the removal of the ball joints or
rod ends.
5: If equipped with front brakes, disconnect the hydraulic brake lines from the brake bodies.
6: Disconnect the front axle beam from the front springs and remove the axle from the vehicle.
Note: In some configurations the front springs and or shocks will have to be removed in order to remove the
axle beam. Refer to section Front Suspension for information regarding removing the springs and shocks.
Page 30
RE-380-36 & RE-380-48
MR-380-05