Table of Contents
Advertisement
6.
Optional accessories
6.3.3 Knife holder N/NZ
The knife holders N and NZ are appropriate for standard steel and tungsten carbide
knives, profile c and d, up to 16 cm long. The integrated height adjustment feature allows
you to also use knives that have been resharpened numerous times.
Mounting the knife support bar
Enlarged detail:
Knife inserted and
height-adjusted.
Knife holder N
For holding
conventional knives up
to 16 cm in length.
8
49
38
• Push knife guard (8) to the center.
• Set the knife support bar (46) onto the height adjustment screws (not
visible) as shown. The flat ends of the height adjustment screws must
be located in the slots at each end of the knife support bar.
Prior to inserting the knife, both knife holder and knife holder
base must have been installed on the instrument!
49
39
46
48
Knife holder NZ
For holding conventional and hard
metal knives up to 16 cm in length.
Knife pressure plate (56) for extreme
stability and full utilization of the
knife blade.
47
56
Instruction manual V 1.1 – 02/2005
Fig. 36
Advertisement
Table of Contents
