A-3. Leakage Current Statement; A-4. Emc Tables; Table 5. Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Schick USBCam2 User Manual

A-3. Leakage Current Statement

A-4. EMC Tables

Table 5. Guidance and Manufacturer's Declaration - Electromagnetic Emissions

PLEASE NOTE: The USBCam2 is intended for use in the electromagnetic environment specified
below. The customer or user of the USBCam2 must ensure that it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
USBCam2 User Guide
USBCam2 complies with the leakage current requirements of IEC
60601-1-1 safety standard. Variations, however, may exist in the
construction of computers to which the USBCam2 is connected.
Users are advised to have a qualified electrician perform a leakage
test on their equipment before using the USBCam2.
The following tables provide USBCam2 compliance information to
electromagnetic compatibility (EMC) and electromagnetic immunity
(EMI) standards. To ensure conformance, the customer or user must
use the USBCam2 in environments that are consistent with these
standards.
The USB cable required with the USBCam2 camera must also
comply with the same standards. To meet those specifications, the
USB A-B type cable should not exceed a maximum length of 5
meters (5.5 yards). Cables longer than that distance may result in
increased emissions or decreased immunity.
Compliance
Group 1
Class B
Class D
Complies
B1051061 Rev. A
Guidance
The USBCam2 uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
The USBCam2 is suitable for use in all establishments
including domestic establishments and those directly
connected to the public low-voltage supply network that
supplies buildings used for domestic purposes.
25