Installing The Usbcam2 Handpiece Holder; Figure 3. Handpiece Holder Instrument Rail Installation - Schick USBCam2 User Manual

Hide thumbs Also See for USBCam2:

Table of Contents

2.6. Installing the USBCam2 Handpiece Holder

PLEASE NOTE: When selecting the mounting option for your USBCam2, choose a

location that offers easy access during patient exams and safe storage afterwards. In most

practices, mounting the USBCam2 to the dental unit will provide the best all-around

solution.

2.6.1. Dental Unit Option

The USBCam2 Handpiece Holder turns off the camera when the

handpiece is inserted and turns on the camera when the handpiece is

removed. The holder is designed for several mounting options: (1)

Mounted to a standard ½-inch dental instrument bar, or (2) Wall-

mounted with fastening hardware.

To install the handpiece holder (Figure 3) to a standard ½-inch

instrument bar, perform the following steps:

1. Remove the handpiece from its holder before performing this

procedure.

2. Remove the cutout block from the holder by untightening

and retaining 2 Phillips screws.

3. Attach the holder to the instrument rail mounting block by

tightening 2 Phillips screws removed previously.

4. Position the holder on the instrument bar of your dental unit,

using the cutout space on the back of the mounting block as

a guide.

5. When the holder is in position, use an Allen key to tighten 2

set screws located at the bottom of the mounting block.

B1051061 Rev. A

USBCam2 User Guide

Table of Contents