Connecting The Usbcam2; Figure 1. Usb Cable Connectors; Figure 2. Usbcam2 Listed In Device Manager - Schick USBCam2 User Manual

2.5. Connecting the USBCam2

IMPORTANT! Do not connect the USBCam2 and cable to your computer until after you
have successfully installed the USBCam2 driver, as described in the previous sections.
USBCam2 User Guide
The USB 2.0 cable used with the camera has a Series "A" USB
connector on one side and a Series "B" USB connector on the other
(Figure 1). The "A-type" connector fits any available USB port on
the computer. The "B-type" connector fits the handpiece. For EMC
and EMI compliance, the USB cable should not exceed a maximum
length of 5 meters (5.5 yards).

Figure 1. USB Cable Connectors

As a final check that your USBCam2 is ready for use, open the
Device Manager (Windows Start > Control Panel > System >
Device Manager). In Device Manager, expand the Imaging devices
folder: Schick Technologies USBCam2 will be displayed there.

Figure 2. USBCam2 Listed in Device Manager

B1051061 Rev. A 9