General Terms; Symbols; Responsibility For Atex Certification - Scope Of Supply - SPX FLOW APV DELTA SD4 Series Instruction Manual

APV
APV_SD4_ATEX_UK-0_122018.indd
Double seal valve
DELTA SD4-ATEX
Instruction Manual: UK - rev. 0
1.

General Terms

This instruction manual applies for DELTA SD4 double seal valves
in the nominal dimensions DN25-100, 1"-4" for use in specific ATEX
applications (according to Directive 2014/34/EU).
The valve must only be assembbled, disassembled and
reassembled by persons who have been trained in APV valves or by
SPX FLOW service team members. If necessary, contact your local
SPX FLOW representative.
This instruction manual must be read and observed by the
responsible operating and maintenance personnel.
We point out that we will not accept any liability for damage or
malfunctions resulting from the non-compliance with this instruction
manual.
Descriptions and data given herein are subject to technical changes.
1.1.

Symbols

This symbol draws your attention to important directions which have
to be observed with regard to the operation in explosive areas.
This technical safety symbol draws your attention to important
directions for operating safety. You will find it wherever the activities
described are bearing health hazards or risks for persons or
material assets.
1.2. Responsibility for ATEX certification - scope of supply
SPX FLOW will be held responsible only for the valves supplied
and selected according to the operating conditions indicated by the
customer or end user and as stated in the order confirmation. If in
doubt, contact your local supplier.
All other assembled equipment and devices must have a separate
certification of at least the same or higher grade of protection
as the valve, provided by the supplier(s) of that equipment and
devices. The complete unit must be certified separately by the final
assembling manufacturer and must have a separate name plate
supplied by the unit manufacturer.
UK
2