Table of Contents
Advertisement
T R O U B L E S H O O T I N G T I P S
Mirror Ball Attached To Motor Does Not Rotate or Rotates Inconsistently
1. Confirm the motor has AC power.
2. Check if circuit breaker that controls the AC outlet the motor is plugged into is not tripped.
3. Confirm the AC power cord from the motor is not damaged or cut.
4. Confirm the eyelet attached to the mirror ball is not damaged or loose.
5. If none of these solutions work, please contact ADJ Customer Service.
Motor Makes Noise When Rotating
1. Disconnect AC power from the motor, remove mirror ball, and uninstall the motor.
2. Inspect the motor for any signs of damage such as from water or moisture.
3. Place the motor on a flat surface and connect to an AC power source.
4. If motor makes noise while rotating, please contact ADJ Customer Service.
5. If not, carefully rotate the motor facing the axel shaft toward the ground.
6. If motor makes noise while rotating, please contact ADJ Customer Service.
7. If not, confirm the motor can support the weight of the mirror ball.
8. If none of these solutions work, please contact ADJ Customer Service.
F R E Q U E N T L Y A S K E D Q U E S T I O N S
Listed below are a few answers to common questions users may have.
1. Can the M-1616 be mounted onto to a ceiling?
Yes, it can be installed onto a flat ceiling surface that can support 10 times the combined total weight
of the attached mirror ball, motor and any mounting accessories. Careful planning must be used
when calculating the combined weight and determining if the flat ceiling surface can support the
weight of the motor and mirror ball. PLEASE CONSULT A PROFESSIONAL FOR CEILING
INSTALLATION GUIDANCE!
2. What mirror ball motor works with the M-1616?
The ADJ M-103HD 0.8-1 R.P.M. mirror ball motor will offer you the needed support for mirror balls up
to 20 inches (51 cm) in size.
3. Is a light included with the M-1616?
No. However, a variety of lighting fixtures and options are available at www.adj.com.
4. How do you clean the mirror ball?
Clean the external of the mirror ball surface at least every 20 days with a soft cloth to avoid dirt/debris
accumulation. NEVER use alcohol, solvents, or ammonia-based cleaners.
14
Advertisement
Table of Contents
