Table of Contents
Advertisement
68 Appendix B: Technical information
Board summary
Global information
• Operating system: See your software manual for supported versions of Microsoft
Windows and Linux.
• Minimum computer requirements:
- x8 (or x16) PCIe slot
- Processor with an Intel 32-bit or 64-bit architecture, or equivalent.
- A relatively up-to-date PCIe chipset. The list of platforms that are known to be
compatible with Matrox Radient eCL are available on the Matrox website,
under the board's PC compatibility list.
- A proper power supply. Refer to the Electrical specifications section.
Matrox does not guarantee compatibility with all computers that have the above
specifications. Please consult with your local Matrox Imaging representative, local
Matrox Imaging sales office, the Matrox web site, or the Matrox Imaging
Customer Support Group at headquarters before using a specific computer.
Technical features of Matrox Radient eCL
• Matrox Radient eCL-DB has two independent acquisition paths; Matrox Radient
eCL-QB has four independent acquisition paths. Each acquisition path supports
a video source in the Camera Link Base configuration.
• Matrox Radient eCL-SF has a single acquisition path; Matrox Radient eCL-DF
has two acquisition paths. Each acquisition path supports a video source in the
Camera Link Medium or Full configuration.
• Processing FPGA. The Processing FPGA can be either an Altera Stratix III FPGA
(EP3SL150, EP3SL200, EP3SL340, EP3SE110, or EP3SE260) or an Altera
Stratix IV FPGA (EP4SE530 or EP4SE820).
*. Note that you can also install Matrox Radient eCL in a x4 PCIe slot that has a
mechanical x8 connector; however, the maximum transfer rate between Matrox Radi-
ent eCL and the Host is reduced by 50%.
*
.
Advertisement
Table of Contents
