Matrox Radient eCL Series Installation And Hardware Reference page 23

Warning
5. Anchor the board using the screw that you removed in step 3.
6. If required, install the cable adapter bracket of your Matrox Radient eCL board,
as described in the section Installing the cable adapter bracket, later in this chapter.
7. Attach your video sources, as described in the section Connecting video sources,
later in this chapter.
When connecting a video source in Full configuration, ensure that you are
❖
connecting its cables to the appropriate connector. Accidentally connecting the
cables to the wrong connector can damage the board or your video source. Pins
2-5 and pins 15-18 are output pins on the top connector (0 and 2), while they
are input pins on the bottom connector (1 and 3).
8. Turn on your computer.
When you boot your computer under Windows, Windows' Plug-and-Play
❖
system will detect a new Multimedia Video Device and you will be asked to
assign it a driver. At this point, you should click on Cancel.
Under Windows and Linux, the driver will be installed during the installation of
Matrox Radient eCL software.
9. Under Windows, to maximize the performance of Matrox Radient eCL and to
minimize the possibility of dropped frames, set the Power Plan option to High
Performance.
Installing your Matrox Radient eCL board 23