Programming Conventions; Using The Control Panel; Programming; Programming Options - Honeywell LTE-X series Installation And Setup Manual

Programming Conventions

•
Programming is accomplished by answering a series of prompts. Most prompts require only a [Y]es or [N]o
response, while others require a numerical response (ID numbers, etc.).
•
The current value is displayed on the second line in parentheses ( ). A "?" indicates an invalid entry.
•
Use the [] key to scroll through options.
•
Use the [ENTER] key to accept the current entry and proceed to the next prompt. If the entered value is invalid,
pressing [ENTER] re-displays the prompt; the next prompt is not displayed until a valid answer is entered.
•
Use the up/down arrow keys to scroll through the programming prompts without changing any values.
•
Press the [ESC] key to go to the end of the list of prompts.

Using the Control Panel

Some control panels support programming of the communicator through the control panel programming mode. For a
description of key functions on the control panel keypad, and how they map to the 7720P programming tool, refer to the
control panel's Programming Guide.

Programming

The communicator supports ECP messaging to communicate with the control panel. Likewise the control panel sends
Contact ID format alarms to the communicator via the ECP bus. Not all control panels support the communicator
interface on ECP, so be sure to check the control panel's Installation and Setup Guide to see if it supports this feature.
Press the [ENTER] key to begin programming.
NOTE: The central station can remotely block access to local
device programming. If this has been done, prompt on the
right appears.
The default programming values for each prompt are shown in parentheses in the PROMPTS column. Further, the
"Programming Options" table (next page) shows all the prompts for this programming mode. Depending on your answers,
unnecessary prompts will be bypassed and you will advance to the next appropriate prompt.

Programming Options

PROMPTS
1
Strt Prog Mode?
(Y/N)_
2
Enter Password
3
Program Device?
(Y/N)_
4
Create Password?
(Y/N)_
LTE-X Series Installation and Setup Guide
ENTRY OPTIONS
[Y], [N]
[0-9, A-F, N, S, T,
X, Y]
[Y], [N]
[Y], [N]
Access to Prog
Mode Denied
Enters programming mode.
If a password has been previously assigned, this prompt
appears.
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
The next prompt appears.
To begin programming the communicator, press [Y] and
go to Prompt 9: " Multi Mode."
To create a password if none has been assigned, press
[N] and go to Prompt 4: "Create Password?."
To change an existing password, press [N] and go to
Prompt 5: "Change Password?."
Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt appears
after pressing [N] at the "Program Device?" prompt.
If a password is desired, press [Y] and go to Prompt 6:
"Enter Password."
– 7 –
DESCRIPTION