Cleaning The Back Surface Of The Reading Glass - Canon F1 Service Manual

4
Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Cleaning the Back Surface of the Reading Glass > Procedure

Cleaning the Back Surface of the Reading Glass

■ Preparation
1) Removing the DADF Front Cover (Refer to page 4-39).
■ Procedure
1) Open the DADF, and slide the Reading Glass [1] in the direction of the arrow to remove it.
• 1 Claw [2]
[1]
[2]
2) Clean the back surface [1] of the Reading Glass with wet and tightly-wrung lint-free paper [2].
3) Install the Reading Glass and the Front Cover to the original positions.
4 Parts Replacing and Cleaning > Consumable parts for periodical replacement and locations for cleaning (DADF) > Cleaning the Back Surface of the Reading Glass > Procedure
F-4-129
[1]
[2]
F-4-130
CAUTION:
When installing the Reading Glass [1], slowly and carefully slide it in. If you slide it in
abruptly, the Film Sheet [2] may flip. (This will result in a jam at DADF reading.)
4-49
[1]
[2]
F-4-131
4-49