Canon F1 Service Manual page 89

4
Parts Replacing and Cleaning > Removing from the connection equipment (Reader) > Removing the DADF + Reader Unit > Procedure
16) Install the Reader Support Plate [B].
• 1 Screw [1]
CAUTION:
When lifting down the DADF + Reader Unit from the host machine, be sure to install the
Reader Support Plate [B] to the DADF + Reader Unit before lifting it down. This is to
prevent deformation of the bottom of the Reader Unit.
[1]
[B]
CAUTION:
When lifting up/down the DADF + Reader Unit, be sure to hold the position [A] shown in
the figure.
[A]
4 Parts Replacing and Cleaning > Removing from the connection equipment (Reader) > Removing the DADF + Reader Unit > Procedure
[A]
[B]
F-4-27
[A]
F-4-28
17) Lift the DADF + Reader Unit [1] with 2 or more people and place it on the floor by passing
over the front side of the host machine.
CAUTION:
Because the center of gravity of the equipment is at the rear, be careful not to drop it
when lifting it.
NOTE:
When installing to the host machine, place the DADF + Reader Unit temporarily on
the floor with the pin [1] of the host machine and the hole [2] of the DADF + Reader
Unit located as shown in the figure. Then, place the DADF + Reader Unit on the host
machine from the front side of the machine.
[2]
4-13
[1]
F-4-29
[1]
F-4-30
4-13