Table of Contents
Advertisement
Cleaning the Platen Glass
If the platen glass is dirty, originals may not be scanned clearly, or the size of the original may not be detected clearly.
1
Turn the power OFF, and remove the power plug from the power outlet.
Turning OFF the Machine(P. 112)
●
Check the operation status of the machine before turning the power OFF. You can turn the power OFF
even if the machine is executing an operation, but this may cause the operation to be interrupted or data
to become damaged.
2
Open the feeder or the platen cover.
3
Wipe the reverse side of the feeder or the platen cover and the platen glass.
Wipe the platen glass.
●
Wipe the platen glass with the included cleaning cloth.
●
If the cleaning cloth is dirty, rinse it in water and dry it before using it.
Wipe the reverse side of the feeder or the platen cover.
●
If you cannot remove the dirt, wet a soft cloth with water and wring it out well, then wipe the
reverse side of the feeder or the platen cover with it. Afterwards, wipe the reverse side of the
Maintenance
603
6C6U-09W
Advertisement
Table of Contents
