System Information (Read Only) - DSC 3G2060 Installation Manual

Ethernet/Cellular Programming Options

System Information (Read Only)

NOTE: Sections [987] - [998] are provided for information (Read Only). Values in these sections
cannot be modified by the Installer.
[987] Language Version
This section will display the current Language version of the Communicator.
[988] DNS 1 IP Address
This section will display the IP address of DNS Server 1. This is useful when the unit is configured
for DHCP and you need to see the IP address was assigned to the device by the DHCP Server. This
value is programmed in Section [007] or assigned by DHCP.
[989] DNS 2 IP Address
This section will display the IP address of DNS Server 2. This is useful when the unit is configured
for DHCP and you need to see the IP address that was assigned to the device by the DHCP Server.
This value is programmed in Section [008] or assigned by DHCP.
[990] Boot Loader Version
This section will display the current Boot Loader version of the Communicator.
[991] Firmware Version
This section will display the current firmware version of the device. Update worksheets with new
version after a flash update is completed.
[992] Ethernet IP Address
This section will display the IP address of the Ethernet connection. This value is programmed in
Section [001] or assigned by DHCP.
[993] Ethernet Gateway Address
This section will display the IP address of the Ethernet Gateway. This value is programmed in Sec-
tion [003] or assigned by DHCP.
[994] Cellular IP Address
This section will display the current dynamic IP address assigned by DHCP to the Cellular con-
nection.
NOTE: Cellular uses DHCP (Dynamic IP) only. The Cellular IP address is always provided by the
Cellular network (i.e., not programmable).
[995] SIM Number
This section will display the Subscriber Identity Module (SIM) number of the SIM card installed
in the Communicator. Format is: Major Industry Identifier (2 digits) Mobile Country Code (2 or 3
digits); Mobile Network Code (2 - 3 digits); Unique Number (10 - 12 digits); and Checksum (1
digit). Valid SIM numbers range is: 18 - 21 numbers. This number is printed on SIM and the out-
side of the Communicator carton.
NOTE: The Checksum digit is omitted on 19-digit SIM Card numbers.
[996] Cellular Telephone Number
NOTE: This section will display the Cellular telephone number of the SIM. This telephone num-
ber is required by the Installer for DLS and remote firmware (flash) update. User can access this
telephone number by entering [*] [6] < > "Cellular Phone No." to display the phone number.
[997] IMEI Number
This section will display the unique 15-digit International Mobile Equipment Identity (IMEI) of
the radio. Format is: Reporting Body Identifier (2 digits), Allocation Number (4 digits); Final
Assembly Code (2 digits); Serial Number (6 digits); and a check digit.
[998] MAC Address
This section will display the unique12-digit, hexadecimal number assigned as the Media Access
Control (MAC) address of the device.
3G Alarm Communicator Installation Manual
25