DSC 3G2060 Installation Manual page 10

Installing Cellular/Ethernet Communicator in
d. Place the second nylon washer (flat), followed by the brass washer and the brass nut, onto
the threaded section of the cable, outside the panel. Tighten the assembly by hand only.
(Finger tight only- Do not overtighten the antenna assembly).
e. Locate the screw hole on the right side wall of the
panel. See Figure 2 (screw). Line up the assem-
bled Communicator with the right side wall of the
panel and, using the screw provided, secure the
mounting bracket to the panel.
f. Attach the other end of the PC-LINK cable to the
Communicator (black wire goes on Pin 1 of the
Communicator).
g. Using light pressure (finger tight only), attach the
supplied white quad band whip antenna to the
threaded antenna connection point at top of the
panel.
WARNING! - 3G2060/TL2603G/TL260 modules are
power limited. Do not route any wiring over the
circuit board. Maintain at least 1in. (25.4mm) sepa-
ration between circuit board and wiring. A mini-
mum of ¼ in. (7mm) separation must be
maintained at all points between non-power lim-
ited wiring and power limited wiring.
3. To electrically connect the Communicator to the panel, perform the following steps
(See Figure 3).
a. Disconnect both AC power and battery connections from the panel, and disconnect tele-
phone line.
Module Power Connection
b. Attach a wire from the Communicator's left PWR terminal to the panel's BELL+ terminal.
c. Attach a wire from the Communicator's GND terminal (beside PWR) to the panel's AUX -
terminal.
d. Attach a wire from the Communicator's SHLD terminal to the panel's EGND terminal.
(Protective earth ground).
(Optional) External Bell/Siren Connection
e. Attach a wire from the Communicator's right PWR terminal to the positive (+) terminal on
the Bell/Siren.
f. Attach the panel's BELL - terminal to the negative (-) terminal on the Bell/Siren.
NOTE: If an external Bell/Siren is not used, install the 1K ½W 5% resistor (Brown, Black, Red,
Gold) (supplied with the panel) between the panel's Bell + and Bell - terminals, then only wire
the BELL + to the PWR terminal on the Communicator.
g. Confirm that the SIM card is inserted in the holder and locked.
3G Alarm Communicator Installation Manual
Figure 2:PC1616/1832/1864 Control Panel
Cable Connector
PC1616/1832/1864
6
Quad band
PC-Link
Whip Antenna
Use light pressure
to attach antenna
Finger Tight
GSM Radio
RJ-45
only.
(screw)