Position Of Kick Back Cam - Scott 10,000 Instruction Manual

KICK BACK CAM
Fig. 4-22. Locate the Kick Back Cam
TIMING MARKS
KICKBACK
CAM
15°
Fig. 4-23. Position of Kick Back Cam
C9999- -2 Issue 1
4.2.8

Position of Kick Back Cam

Step: 1. Locate the kick back cam that moves the
kick back rollers up and down.
Note !
Kickback cam does not require
alignment when the flat of the cam is
15 degrees offset. The left side is
higher than the right side. A wedge
can be made to fit.
Step: 2. Timing marks are located on the
kick--back cam and machine frame.
Step: 3. Reach under the reregister section and
grab hold of reregister belt drive shaft.
Step: 4. Rotate shaft until the timing marks are
aligned.
4 Maintenance
4- -19