Crate 2 -- Additional Assemblies; Install Tab Cutter Unit - Scott 10,000 Instruction Manual

2 Installation
2.3.2 Crate 2 - - Additional Assemblies
Crate 2 contains all remaining equipment that was removed for shipping.
Chip Removal Vacuum
Tab Cutter Assembly
Cross Conveyor Assembly
Instruction Manual
Miscellaneous Parts
CHIP REMOVAL VACUUM
Fig. 2-5. Scott 10,000 on Shipping Skid (Crate 2)
Step: 1. Remove Cross Conveyor assembly from shipping skid. Place it to the side for later installation.
Step: 2. Remove vacuum unit from skid.
REREGISTER EXTENSION
MOUNTING SHAFT
Fig. 2-6. Remove Support Shaft
2- -6
2.3.3

Install Tab Cutter Unit

Step: 1. Loosen hardware and slide reregister
extension frame mounting support shaft
out of tab cutter frame housing.
CROSS CONVEYOR UNIT
TAB CUTTER UNIT
C9999- -2 Issue 1