Table of Contents
Advertisement
TAB SIZE
HANDWHEEL
Fig. 3-68. Set Handwheels for Tabs
Step: 6. Use the charts in the back of this section to set the machine up for the desired tabs.
Fig. 3-69. Heater Controls
C9999- -2 Issue 1
TAB POSITION
HANDWHEEL
PLASTIC SIZE
HANDWHEEL
Step: 7. If laminating plastic to paper, check heat
controls to see if they have reached their
operating temperature.
Note !
The starting point for the heaters is
220- 230
F. This may need to be
_
changed depending on thickness of
stock and the length or type of plastic
Temperature is dependant on paper
and plastics being run.
Ex. Clear heavyweight film with
90- 110lb. index stock, 2- 3 inch plastic
length will need 300- 325
"7" on the speed control.
The heavier the stock and longer the
paper length, the faster the speed and
more heat is necessary. Thinner
stocks and shorter lengths of plastic
require lesser temperature. Always
keep temperature as low as possible.
3 Operation
PLASTIC
POSITION
HANDWHEEL
F running at
°
3- -33
Advertisement
Table of Contents
