Scott 10,000 Instruction Manual page 112

PILE FEEDER DRIVE GEARS
FRONT
Fig. 4-4. Paper Feeder
GREASE FITTING
Fig. 4-5. Grease Fitting - - Inside Pile Feeder
4.1.2.1 Feeder
There are four grease fittings on the paper feeder.
Two fittings located on the ends of the vacuum bar.
One fitting is located on the back side of the pile lift rocker arm cam follower and must be accessed from
inside the pile feeder.
One fitting is located on the pile lift shaft.
To lubricate, remove pile feeder covers. All fittings should be greased every 200 operating hours or once a
month. One shot of grease is all that is necessary.
C9999- -2 Issue 1
VACUUM BAR
GREASE FITTING
VACUUM BAR
GREASE FITTING
PILE FEEDER LIFT GEARS
PILE LIFT
GREASE FITTING
4 Maintenance
PILE
LIFT
CAM
REAR
4- -5