Table of Contents
Advertisement
4 Maintenance
REREGISTER SLIDE
OPERATING ARM
Fig. 4-24. Locate the Reregister Section (View
from Under Machine)
15_
CLAMP SCREW
(SOCKET HEAD)
Fig. 4-25. Position of Reregister Slide Operating
Arm
4- -20
GEARBOX SHAFT
CONNECTING
BLOCK
GEARBOX
CLAMP SCREW
CONNECTING
BLOCK
7 O'CLOCK
6 O'CLOCK
4.2.9
Reregister Section
Reregister section is located after the heat rollers
underneath the cross conveyor before the tab
cutter end of the machine. The reregister arm is
attached to the gearbox output shaft. The gearbox
drives the reregister slide operating arm or "jogger"
back and forth.
Step: 1. The socket head clamp screw located on
the block should be aligned to the 7
o'clock position when viewed from the
tab cutter end of the machine.
Step: 2. To reposition clamp screw, loosen screw
and rotate block until the screw is in the
correct position.
Step: 3. Retighten screw.
C9999- -2 Issue 1
Advertisement
Table of Contents
