Maintenance Mode - Scott 10,000 Instruction Manual

PILE FEED & CUT
Fig. 4-11. Machine Back View - - Guards Must Be Removed To View Parts
RUN
Fig. 4-12. Maintenance Mode
C9999- -2 Issue 1
MACHINE CYCLE CAM
SAFE
MAINT
TAB CUTTER DRIVE SHAFT
KICK BACK CAM
4.2.1

Maintenance Mode

The Maintenance mode position on the key switch
is used to perform maintenance and diagnostic
functions. Maximum speed of the machine in the
Maintenance Mode can be adjusted to up to 22%
of the maximum machine speed. The machine
will operate with the roller and feeder guards
removed.
Note !
The machine will not operate if the
Tabcutter guard is removed.
4 Maintenance
4- -11