Chain Lubrication - Scott 10,000 Instruction Manual

4 Maintenance
HUB CITY BEVEL GEAR
(UNDER CROSS CONVEYOR)
Fig. 4-2. Kick Back Gearbox Location (Under
Cross Conveyor)
Fig. 4-3. Drive Chains
4- -4
4.1.1.2 Kick Back Gearbox
The Hub City Model M2 gearbox is located under
the cross conveyor assembly.
Do not operate the machine without making sure
that the Kickback gearbox contains the correct
amount of oil. Do not overfill or underfill the unit.
Changing Lubricant
After the first 100 hours of operation, drain initial
oil, flush gear case with an approved
non--flammable, non--toxic, solvent and refill.
Thereafter, oil should be changed every 2500
operating hours or every 6 months whichever
occurs first.
Oil should be changed with greater frequency if the
unit is used in a severe environment such as dusty
or humid.
Recommended Lube:
Hub City GL--90
AGMA Number: 5EP
ISO--ASTM Viscosity Grade: 220
Lube Quantity: .25 pints
Hub City GL--90 Lubricant is a heavy--duty
industrial gear lubricant containing sulfur
phosphorous antiwear additives. Lubricants of this
type may be substituted where Hub City Lubricants
are recommended. Lubricants must be compatible
with nitrile rubber seals.
4.1.2

Chain Lubrication

Use chain lubrication CRC 03050 or Superior
Graphite 35201G. Apply Lubricant to chain with
machine set to 2 or 3 on the speed adjustment
control. Lubricant should be applied before chain
is dry, once a month or about every 200 operating
hours.
Note !
Use CRC 03050 or Superior Graphite
35201G for Chain Lubrication.
C9999- -2 Issue 1