Plastic Size Handwheel - Scott 10,000 Instruction Manual

PLASTIC SIZE
HANDWHEEL
Fig. 4-35. Plastic Position Handwheel
PLASTIC
Fig. 4-36. Turn Plastic Feed ON
3.00
Fig. 4-37. Measure Plastic
Step: 5. To adjust plastic size. remove locking screw that retains nut located on side of plastic feed/tip--die
mounting plate (See Fig. 4-34. ).
Step: 6. By rotating nut clockwise, the plastic lengths will become longer. A counterclockwise rotation will
shorten plastic lengths. Make sure plate location is up against shoulder of the nut when checking
piece size.
Step: 7. Run one piece of paper through machine, then measure the plastic.
Step: 8. If plastic is at desired length, you may then reinstall locking screw. If not, repeat steps 6 and 7 until
desired length is achieved.
C9999- -2 Issue 1
PLASTIC
POSITION
HANDWHEEL
FEED

4.2.16 Plastic Size Handwheel

Step: 1. If power has not been applied to
machine, do so at this time. Make sure
the heaters are turned on and up to
temperature.
Step: 2. Turn plastic feed ON.
Step: 3. Check heaters to see if they are up to
operating temperature.
Step: 4. Run one piece of paper through the
machine.
Note !
If length of plastic equals 3.00 inches
(76.2mm) proceed to next set- up.
If length is more than or less than
3.00 inches (76.2mm), perform the
following steps.
4 Maintenance
4- -27