Table of Contents
Advertisement
3 Operation
3 FILM THICKNESS
Fig. 3-49. Set Gap Between Plastic Feed Roller
Guides to 3 Film Thickness
FILM
SPOOL
Fig. 3-50. Loading the Film
3- -24
3 FILM THICKNESS
DRIVE ROLLER
FOLDING ROLLER GUIDES
FILM
REEL
FILM
GUIDES
Step: 2. Set the gap between the plastic folding
roller guides to three film thickness by
moving the lower roller guide.
Step: 3. Tighten the adjustment knob.
Step: 4. Load film reel on the reel holder.
Note !
Film from the factory is wound on the
spool with the glue side facing out.
Step: 5. Thread film through the film guides as
shown.
C9999- -2 Issue 1
Advertisement
Table of Contents
