Canon Inner Finisher-K1 Service Manual page 82

1. Enter the following Service Mode.
• Adjustment of alignment position (A4):
SORTER > ADJUST > INF-ALG1
• Adjustment of alignment position (LTR):
SORTER > ADJUST > INF-ALG2
2. Enter the setting value -50 (switch negative/positive by -/+ key) and press OK key.
This operation stops the alignment plate at the current alignment position +5.0mm.
3. Set A4 or LTR paper on the processing tray unit.
4. Fit the paper [1] to the leading edge [2] of the rear alignment plate.
5. Measure the gap [a] between the leading edge [3] of the front alignment plate and the edge of the paper.
CAUTION:
Because the front alignment plate is installed a bit tilting toward the delivery direction, set the paper to be fitted to the leading
edge.
6. Enter the gap value measured in the above step 5 in the calculation formula below, calculate the adjustment value.
Adjustment value = gap (mm) x 10 - 50
NOTE:
Correspondence table of measured gap value and adjusted value
Gap mm (measured
value)
1.5
2.0
2.5
3.0
7. Enter the adjustment value and press OK key.
8. Copy 10 sets of 1 original and confirm that an alignment failure and a delivered paper failure do not occur.
Adjustment value
-35
-30
-25
-20
[2]
[a]
[3]
Gap mm (measured val-
ue)
3.5
4.0
4.5
5.0
76
5. Adjustment
[1]
Adjustment value
-15
-10
-5
0