Canon Inner Finisher-K1 Service Manual page 83

9. In case failure occurs again, repeat steps 1 and 8.
10. Remove paper on the processing tray.
11. Enter the values of service mode items recorded on the service label of the finisher rear cover.
■ Adjusting Center Alignment Standard Position
<Use case>
• When the standard position for the center alignment is misaligned.
• When misalignment occurs in front/rear direction.
<Procedure of adjustment>
CAUTION:
This adjustment influences alignment operation and staple position.Adjust the alignment width with
Alignment Position " on page
1. Adjust the center alignment by the following service modes.
• SORTER > ADJUST > CENT-ALG
Adjustment range: -10 to 10 (Unit: 0.1mm)
As the value is incremented by 1, the standard position for the center alignment moves by 0.1 mm.
+: Toward rear
-: Toward front
Feed Direction
73.
Feed Direction
Feed Direction
Alignment Plate
+
-
+
-
Alignment Plate
77
5. Adjustment
"Adjusting Stacker