Canon Inner Finisher-K1 Service Manual page 80

3. Set A4 or LTR paper on the processing tray unit.
4. Fit the paper [1] to the leading edge [2] of the rear alignment plate.
5. Measure the gap [a] between the leading edge [3] of the front alignment plate and the edge of the paper.
CAUTION:
Because the front alignment plate is installed a bit tilting toward the delivery direction, set the paper to be fitted to the leading
edge.
6. Enter the gap value measured in the above step 5 in the calculation formula below, calculate the adjustment value.
Adjustment value = gap (mm) x 10 - 50
NOTE:
Correspondence table of measured gap value and adjusted value
Gap mm (measured
value)
1.5
2.0
2.5
3.0
7. Enter the adjustment value and press OK key.
8. Copy 10 sets of 1 original and confirm that an alignment failure and a delivered paper failure do not occur.
9. In case failure occurs again, repeat steps 1 and 8.
10. Remove paper on the processing tray.
11. Enter the values of service mode items recorded on the service label of the finisher rear cover.
Adjustment value
-35
-30
-25
-20
[2]
[a]
[3]
Gap mm (measured val-
ue)
3.5
4.0
4.5
5.0
74
5. Adjustment
[1]
Adjustment value
-15
-10
-5
0