Adjusting The Staple Position - Canon Inner Finisher-K1 Service Manual

1. Adjust return belt puressure by the following service mode.
• SORTER > ADJUST > RBLT-PRS
Adjustment range: -10 to 10 (Unit: 0.1 mm)
As the value is changed by 1, the height of the return belt changes by height of 0.1 mm.
+: Downward
-: Upward

Adjusting the Staple Position

■ Adjusting the Staple Position
<Use case>
• When the staple position in front/rear direction is displaced in the front/rear 1-stapling mode or 2-stapling mode.
<Procedure of adjustment>
NOTE:
After the setting value is changed, write the changed value in the service label.
-
+
Feed Direction
<Front stapling/Rear stapling>
Return belt
Feed Direction
< 2-point stapling>
81
5. Adjustment
Feed Direction
− ＋