Daikin TSTATD2200C-2 Owner's Manual And Installation Instructions page 14

D_TSTATD2200C-2_Manual_HR.pdf
Installation Instructions
Explanation of Thermostat Jumpers
Jumpers are located on the back of the thermostat
GAS RV=O GAS/ELEC
J3 J2 J1
ELEC RV=B HEATPUMP
This jumper configures the thermostat to control a conventional
GAS/ELEC GAS/ELEC
J1
gas/electric system or a heat pump. If your system is anything
OR
other than a heat pump, leave this jumper set for GAS/ELEC.*
HEATPUMP HEATPUMP
*For some commercial heat pumps, this jumper will need to
be set for GAS/ELEC. Consult the commercial heat pump literature.
When J1 is configured to control a heat pump, this jumper (J2)
RV=O RV=O
J2
must be set to control the appropriate reversing valve. If RV=O
OR
is chosen, the W1/O/B terminal will energize in cooling. If RV=B
is chosen, the W1/O/B terminal will energize in heating.
RV=B RV=B
When J1 is set for GAS/ELEC:
GAS GAS
This jumper (J3) controls h
J3
Fan (G) terminal in heating mode. When GAS is chosen, the
OR
thermostat will not energize the Fan (G) terminal in heating.
ELEC ELEC
When ELEC is chosen the thermostat will energize the fan in
heating.
18 8/29/13
GAS RV=O GAS/ELEC
J3 J2 J1
ELEC RV=B HEATPUMP
ow the thermostat will control the
PAGE 10
1:11 PM