Emergency Heat; Using The Fan Button - Daikin TSTATD2200C-2 Owner's Manual And Installation Instructions

D_TSTATD2200C-2_Manual_HR.pdf
User Setup

Emergency Heat

To initiate the Emergency Heat feature, Press and hold the EMERGCY HEAT button
for 2 seconds. During Emergency Heat operation the thermostat will turn on the fan
and auxiliary stages of heat when there is a demand for heat. The 1st stage of
heating and all stages of cooling will be unavailable. To exit Emergency Heat,
press the EMERGCY HEAT button.
Accessory
The ACCESSORY button allows the user to view wired
and wireless sensors and "link" these and other wireless
devices to the thermostat via an optional RF module.
Press the ACCESSORY button to enter the Accessory setup screen. Press UP
to view linked and wired accessories. Follow the instructions included with the
wireless accessory to begin linking process. Next, press DOWN to enter the
wireless linking mode. Press MODE to initiate linking. Press ACCESSORY to
return to the main screen. NOTE: A wired outdoor sensor's temperature reading
is updated once every minute; a wireless outdoor sensor's temperature reading
is updated once every 5 minutes.

Using the Fan Button

Fan On indicates constant fan operation. Pressing the FAN button
toggles this feature on or off.
Using the Service Button
SERVICE - Press the SERVICE button to display who to call for heating
and cooling system repair. Press the SERVICE button again to return to normal
operation.
Note: The TSTATGAC-UP USB Programmer will need to be used to
program the service information into the thermostat.
25 8/29/13
The Emergency Heat function is only
available if your thermostat is set to
control a Heat Pump.
The optional RF Module
must be installed to link
and view wireless accessories.
PAGE 17
1:11 PM