FLIR PT-606Z HD Installation Manual page 36

2 Basic Operation and Configuration
Sensor > Communications > Serial Remote
Sensor > Communications > VMS Remote
If the camera is used with a VMS that is compliant with ONVIF, the parameters can be adjusted (if
needed) to work with the VMS. Refer to the VMS documentation to determine what parameter values
are needed. By default, the camera is configured with a VMS Remote interface with ONVIF 2.0
parameters (Profile S).
Authentication when enabled uses the same passwords set from the Server Security Options page.
Refer to
(VMS) are supported by FLIR IP cameras. Because these systems tend to evolve and change over
time, contact the local FLIR representative or FLIR Technical Support to resolve any difficulties or
questions about using this feature.
427-0075-01-12 Version 110
Toggle Server (Stop/Start)
Server > Security Options, pg. 35. Several types of third-party Video Management Systems
November 2017
Bosch
settings
Pelco-D
settings
Select
protocol
Save
For ONVIF,
use the settings
in Interface 1
36