Set Ip Address Using The Flir Discovery Network Assistant (Dna) - FLIR PT-606Z HD Installation Manual

Table of Contents

Advertisement

2
Basic Operation and Configuration
Test serial communications by connecting a serial device such as a keyboard and confirm the camera
is responding to serial commands. It may be necessary to configure the serial device interface to
operate with the camera.
Once the camera is connected to a network and powered on, set camera network parameters using
the FLIR Discovery Network Assistant (DNA) software, perform a bench test by using a web browser
to view the video and control the camera, or view video in the local Network Video Management
System (for example, FLIR Latitude
free download from the
a license to use.
2.2.1
The PT-Series HD camera is shipped with Dynamic Host Configuration Protocol (DHCP) enabled to
assign IP addresses. Assuming the existing network has a DHCP server, the camera will be assigned
an appropriate IP address. If the network does not have a DHCP server, the PT-Series HD camera will
default to 192.168.0.250. Configuring the camera for IP communications generally involves the
following steps:
Step 1
Step 2
Step 3
427-0075-01-12 Version 110
http://www.flir.com/security/display/?id=73533

Set IP Address using the FLIR Discovery Network Assistant (DNA)

Connect the Ethernet port of the camera to the existing IP camera network.
Connect a PC or laptop to the same network.
From the PC connected to the camera network, use the DNA utility to discover and display
the camera's current IP address.
a
Download the DNA utility (2.1.3.15 or later) from the FLIR Firmware & Software
Downloads page at: http://www.flir.com/security/display/?id=73533.
b
Unzip the utility, then double-click to run the executable file (
the VLAN are discovered.
c
For additional instructions on using DNA, refer to the DNA User's Manual available in the
Help (
) link while the software is running.
Click to sort
tm
). The FLIR Discovery Network Assistant (DNA) software is a
November 2017
web page and does not require
DNA.exe). All the units on
Online manual
Select a filter
Right-click
Select Assign IP
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents