Dimension Drawings; Wall Mounting - Siemens SCALANCE X-100 Commissioning Manual

Installation and Maintenance

5.4 Wall Mounting

Figure 5-3
Uninstalling
To remove the Industrial Ethernet switches of the SCALANCE X-100 and X-200 product
lines from the SIMATIC S7-300 standard rail:
1. First disconnect the TP cables and pull out the terminal blocks for the power supply and
2. Loosen the screws on the underside of the standard rail and lift the device away from the
5.4 Wall Mounting
Wall Mounting
1. For wall mounting, use suitable mounting fittings for the wall
2. Connect the electrical wiring to the terminal block.
3. Fit the connectors for the signaling contact to the terminal block.
4. Insert the two terminal blocks into the sockets on the device.
For more exact dimensions, please refer to the section "Dimension Drawings".
5-4
Installation of a SCALANCE X-100 and/or X-200 on a SIMATIC S7-300 Standard Rail
the signaling contact.
standard rail.
(for example, for a concrete wall, four plugs 6 mm diameter and 30 mm long, 4 screws
3.5 mm diameter and 40 mm long).
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
Commissioning Manual, 1,