Scalance X204-2 Technical Specifications - Siemens SCALANCE X-100 Commissioning Manual

Ports 1 through 8 LED flash yellow
Port 1 through 8 LED flashes green The "Show Location" function was activated over Ethernet (e.g.
LED Display during Startup
Following startup, the following LEDs light up in the following order:
• Power LEDs (green) light up immediately after turning on the power.
• Port LEDs (yellow) light up for approx. 6 s, the red LED is off.
• Port LEDs go off, the red LED is lit for approx. 20 s.
After the port LEDs go off, the correct link status is displayed after approx. 2 s.
The device is now ready for operation.
4.5.10

SCALANCE X204-2 Technical Specifications

Technical Specifications of the SCALANCE X204-2
Ports
Attachment of DTEs or network components over
twisted pair
Connection of further network components over
FOC.
Connector for power supply
Connector for signaling contact
Electrical Data
Power supply
Power loss at DC 24 V
Current consumption at rated voltage
Overvoltage protection at input
Permitted Cable Lengths
Network span parameter/TP cable length
0 – 100 m
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
Commissioning Manual, 1,
Device startup, the LED is lit for approx. 6s.
Setting or display of the fault mask
PST tool).
PROFINET IO operation was started with the PN IO controller,
the attempt to change the fault mask with the button was
rejected by all the port LEDs flashing once.
The button was pressed for longer than 15 s to reset the
configuration.
4 x RJ-45 sockets with MDI-X pinning 10/100
Mbps (half/ full duplex)
2 x 2 BFOC sockets
(100 Mbps, full duplex to 100BaseFX)
1 x 4-pin plug-in terminal block
1 x 2-pin plug-in terminal block
2 x 24 V DC
(18 - 32 V DC)
safety extra-low voltage (SELV)
5.16 W
215 mA
PTC resetable fuse (0.6 A / 60 V)
IE FC standard cable with IE FC RJ-45 plug 180
or
IE FC outlet RJ-45 with IE FC standard cable (0 -
90 m) + 10 m TP cord
Product Characteristics
4.5 SCALANCE X204-2
4-43