Diagnostics Over Industrial Ethernet; Configuration With The Primary Setup Tool; Introduction; Installing The Primary Setup Tool - Siemens SCALANCE X-100 Commissioning Manual

Diagnostics over Industrial Ethernet

The diagnostics over Industrial Ethernet described in the following section is possible only
with devices of the SCALANCE X-200 product line.
6.1

Configuration with the Primary Setup Tool

6.1.1

Introduction

Initial Assignment of an IP Address
There are three ways of assigning an IP address to an unconfigured device, using:
• DHCP
• STEP 7 V 5.3 plus SVP 1
• Primary Setup Tool V3 or higher
• The initial assignment of an IP address for an Industrial Ethernet switch of the
Supported Operating Systems
The Primary Setup Tool can be installed and run under the following operating systems:
• Windows XP Professional
• Windows 2000 Professional SP2
6.1.2

Installing the Primary Setup Tool

Procedure
Follow the steps outlined below to install the Primary Setup Tool on your computer:
Industrial Ethernet SCALANCE X-100 and SCALANCE X-200 Product Line
Commissioning Manual, 1,
Before the IP address can be assigned with the setup tool, the SCALANCE X-200 must
be accessible over Ethernet.
SCALANCE X-200 product line is not possible with Web Based Management because
this configuration tool requires that an IP address is already available.
6
6-1