Sangean PR-D18 Manual
  1. Manuals
  2. Brands
  3. Sangean Manuals
  4. Radio
  5. PR-D18
  6. Manual

Sangean PR-D18 Manual

Version 1
Hide thumbs Also See for PR-D18:

Advertisement

Table of Contents

PR-D18
中文
GB
Version 1

Advertisement

Table of Contents
loading

Related Manuals for Sangean PR-D18

Summary of Contents for Sangean PR-D18

  • Page 1 PR-D18 中文 Version 1...

  • Page 2: Important Safety Instructions

    Important safety instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
  • Page 3 Only use attachments/accessories specified by the manufacturer. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
  • Page 4 Excessive sound pressure on ear- and headphones could impair the hearing ability. Higher setting that idle on the equalizer leads to higher signal voltages on the output for ear and headphones. The power plug should be close to the radio, and easy to be approached that during the emergency, to disconnect the power from the radio, just unplug the power plug from the AC power slot.

  • Page 6: Icon Display

    Control Speaker Band / step button Buzzer alarm button Radio alarm button Volume up / down button LCD display Power / Sleep button Tuning up / down button Display / Clock set button Preset button Headphone socket DC jack socket Battery compartment Key lock switch Telescopic aerial...

  • Page 7: Using The Radio For The First Time

    Using the radio for the first time Battery operation . Remove the battery cover on the rear of the unit by pressing the catch. 2. Insert four UM-3 (AA size) batteries into the spaces in the compartment. 3. Take care to ensure all batteries are inserted with correct polarity as shown on the rear cabinet.
  • Page 8 Using the AC power adaptor The AC power adaptor required for this unit should be 6 volts DC at 0.4 A center pin positive. Insert the adaptor plug into the DC socket on the left side of the radio. Plug the adaptor into a standard mains socket outlet. Whenever the adaptor is used, the batteries are automatically disconnected.

  • Page 9: Operating Your Radio - Search Tuning Am / Fm

    Operating your radio - Search tuning AM / FM . Fully extend the antenna above the radio. Press the Power button to switch on your radio. 2. Press the Band button to select the required band. 3. Press and hold the Tuning up/ down button to start the search tuning.
  • Page 10 Manual tuning – AM / FM . Press the Power button to switch on your radio. 2. Press the Band button to select the required band. Fully extend the antenna for best reception. 3. Press and release the Tuning up/down button to tune to a station. The FM frequency will change in steps of 50/00kHz and AM frequency will change in steps of 9/0kHz.

  • Page 11: Presetting Stations

    Presetting stations You may store your preferred AM/FM radio stations to the preset stations ( to 5). The procedure for setting preset Stations is described below. Note that the radios for AM and FM are saved together in the preset stations so there are 0 of them.
  • Page 12 Software version / Setting up the tuning step increment / 24 / 12 time format Software version The software display cannot be altered and is just for your reference. . Make sure your radio is in power off mode. 2. Press and hold the Band/step button until the software version is shown on the display (e.g.

  • Page 13: Clock Setting

    Clock setting . Press and hold the clock set button until the radio beeps once and the hour digits of time setting begins to flash. 2. Press the Tuning Up / Down button to adjust the hour setting as required. Then press the clock set button to confirm the hour setting.
  • Page 14 4. Press the Tuning up / down button to adjust the volume. Then press the Alarm button to confirm the setting. Now the alarm setting is completed. Once the alarm is set, it will automatically go off the next day at the same time. 5.

  • Page 15: Sleep Timer

    Turning off the sounding alarm Press the Power button to turn off the sounding alarm, otherwise, the alarm will sound for an hour. Cancelling the alarm setting Press and hold the Alarm button until you hear a beep and the alarm symbol will disappear on the display.

  • Page 16: Headphone Socket

    Headphone socket A 3.5mm stereo headphone socket is provided on the left hand side of your radio for use with headphones. Inserting a plug automatically mutes the internal speaker. Note: FM stereo is only available when using headphones. IMPORTANT: Excessive sound pressure from earphones and headphones can cause hearing loss.

  • Page 17: Specifications

    Specifications Power Requirements Mains DC in 6V / 0.4 A Battery 4 X .5V Size “AA” / UM-3 / LR6 Frequency Range FM 87.5 – 08 MHz AM (9K) 520 – 70 kHz AM (0K) 520-70 kHz Circuit Features Loudspeaker 2.25”...

Table of Contents