Power On Projector - Barco UDX Series User Manual

Remote Control Unit buttons
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
25
The projector remote control is a full feature wireless remote control, powered by two (2) standard AA
batteries. The battery compartment is on the back of the remote control.
The remote control is backlit for use in dark environments. It also has an XLR connector for wired connection
to the projector. When the wire is connected, the IR beam is switched off.
LCD panel
The LCD panel has two main functions:
1. Showing the menus, the adjustment information and also a mirror of the OSD, (On Screen Display)
described in User Interface when this is enabled.
Information regarding the status of the projector showing this data:
• Projector status
• Network address
• Active source
• Current firmware version
• Operation Data
• Active functions (Enabled Functions).
Toggle between the two indications by using the Menu button on the keypad, or on the remote control.
The LCD Display will fade out 30 seconds after the last key operation.

4.2 Power on projector

How to power on
1. Press the mains switch at the side of the projector to switch on this projector.
Button pressed indicator
1
24
Shutter open
23
22
Shutter close
21
20
LCD panel On / Off
19
Project OSD On/Off
18
Lens zoom
Lens shift
Menu Open / Close
17
Menu selection, OK
9
button
Menu navigation
10
16
Input selection
11
12 Address button
Numeric buttons
13
26
Getting Started
Backspace (while
14
entering values)
XLR connector
15
Decimal mark (while
16
entering values)
Macro button
17
Menu back
18
Default value button
19
Lens focus
20
Color menu
21
Test patterns
Power On
Power Off
3.5 mm jack
RCU On / Off
R5906112-06 UDX series 41