Switching To Standby; Power Off Projector - Barco UDX Series User Manual

Starting image projection
1. Make sure the available sources are connected to the appropriate input ports.
Tip: If properly connected, the "SYNC" LED will light up ORANGE.
2. Press the Input Selection button on the keypad or on the remote control until:
• the LED of the selected source (the "SEL" LED) lit up GREEN, and
• the image of the selected source is projected.
1
Image 4-3

4.3 Switching to standby

How to switch to standby
1. Press and hold the Power on/off button for 3 seconds on the local keypad, or press the Power Off button on
the remote control.
The projector goes to standby mode. The after-cooling cycle will start (about 30 seconds). During this period
the Power on/off button will blink. Once the after-cooling cycle has ended, the projector will be in standby
mode and the Power on/off button will be lit WHITE.
3 s
Image 4-4

4.4 Power off projector

CAUTION: This procedure assumes the projector is in standby mode.
How to power off
1. Switch off the projector with the mains switch. '0' must be pressed.
2
30 s
Getting Started
R5906112-06 UDX series 43