GUI – Installation
Image 8-17: Bow distortion
Symmetric bow correction
1.
In the main menu, select Installation → Warp.
Image 8-18: Installation menu, Warp
2.
In the Warp menu, select Bow.
Image 8-19: Warp menu, Bow
Tip: A check symbol at the bottom right corner indicates whether or not the bow function is activated.
3.
To enable Bow correction, make sure the Bow slider is set to On (visible by the blue highlight).
4.
To perform a symmetric adjustment , make sure the Symmetric slider is set to On (visible by the blue
highlight).
78
R5906112-06
UDX series